 |
 |
|
|
|
| Aqualease 50 |
 |
Aqualease 50 is a unique stable aqueous emulsion of silicone polymers formulated to release synthetic foam and solid urethane elastomers. Aqualease 50 gives excellent release, and reduces build-up normally associated with water based release agents. Most molded parts can be post finished following solvent vapor degreasing, or hot water alkaline wash and clean rinse.
Aqualease™ 50
Aqualease 50 is a unique stable aqueous emulsion of silicone polymers formulated to release synthetic foam and solid urethane elastomers. Aqualease 50 gives excellent release, and reduces build-up normally associated with water based release agents. Most molded parts can be post finished following solvent vapor degreasing, or hot water alkaline wash and clean rinse.
* Features:
Aqualease 50 is a water based carrier that is low cost and ready to use. Aqualease 50 provides excellent release and film formation with no volatile organic solvents and low toxicity and odor.
* Application:
1. Preheat mold to operating temperature.
2. Spray using a HVLP type spray gun. Apply a light coating before each molding cycle. (Excess release agent may cause surface defects on the molded parts).
3. Should mold build-up occur, dilute Aqualease 50 with 1 part water.
4. Aqualease 50 is a stable water emulsion of silicone polymers, but repeated or prolonged freezing may cause separation. Should this occur, mix well before using. This product will
freeze at 32'F. |
 |
Appearance: Milky Fluid
Weight/Gal: 8.0-8.2 lbs/gal
Freezing Point: 32'F |
|
|
|
|
|
